Anritsu S362E Site Master Cable & Antenna Analyzer
- Cable & Antenna Analyzer: 2 MHz to 6 GHz
- Spectrum Analyzer: Spectrum Analyzer
- Return loss, VSWR, cable loss, DTF
Narda SignalShark 3310 Real-Time Handheld Spectrum Analyzer | 8 kHz to 8 GHz
- Extremely high sweep rate of up to 40 GHz/s
- 40 MHz real-time instantaneous bandwidth
- High time resolution spectrogram
Keysight N5230C PNA-L Microwave Network Analyzer
- 300 kHz – 20 GHz
- IF Bandwidth: 10 Hz
- up to 122 dB dynamic range standard
Anritsu S332E Site Master Cable/ Antenna Analyzer
- Return Loss, Cable Loss, VSWR, Distance-To-Fault
- Phase, 2-port Transmission Measurements
- Spectrum Analyzer, Interference Analyzer with Interference Mapping, High Accuracy Power Meter
Rohde & Schwarz ZNB8 Vector Network Analyzer
- Wide dynamic range of up to 140 dB
- Short sweep times of 4 ms for 401 points
- High temperature stability of typ. 0.01 dB/°C
Rohde & Schwarz FSH18 10 MHz - 18 GHz Spectrum Analyzer
- Frequency range of 10 MHz to 18 GHz
- Reference Level -80dBm to +20dBm
- TOI typ. 7 dBm
Anritsu S331L Site Master Handheld Cable & Antenna Analyzer
- Frequency Range: 2MHz - 4GHz
- Frequency Accuracy: ≤ ±5ppm @25°C
- Frequency Resolution: 1kHz
Keysight E7405A | 9 kHz – 26.5 GHz
- 1 Hz to 5 MHz (including 200 Hz, 9 kHz, 120 kHz, 1 MHz EMI BW)
- +12.5 dBm TOI
- ≤150 dBm displayed average noise level (DANL)
Tektronix RSA6114B Spectrum Analyzer | 9 kHz - 14 GHz
- 20 dBm 3rd order intercept at 2 GHz, typical
- Displayed average noise level –151 dBm/Hz at 2 GHz (–167 dBm/Hz, preamp on, typical) enables low-level signal search
- Revolutionary DPX displays transients with a minimum event duration of 3.7 μs
Rohde & Schwarz FSP38 Spectrum Analyzer | 9 kHz - 40 GHz
- 15 minutes warm-up time at ambient temperature
- specified environmental conditions met, calibration cycle and total calibration
- Data without tolerances: typical values only
Anritsu S331E Site Master Cable and Antenna Analyzer
- Cable and antenna analyzer: 2 MHz – 4 GHz
- Return loss, VSWR, cable loss, distance-to-fault
- Phase, 2-port transmission measurements
Keysight N5225B PNA Microwave Network Analyzer
- Frequency Range | 900 Hz-50 GHz
- Dynamic Range | 127 dB
- Harmonics | -60 dBc
Tektronix RSA5126A Real-Time Spectrum Analyzer
- Frequency Range 1 Hz to 26.5 GHz.
- Trigger Modes: Free Run, Triggered, FastFrame.
- Level Range 0 dB to –100 dB from reference level.
Keysight E5071C ENA Vector Network Analyzer, 9 kHz - 20 GHz
- Wide frequency coverage: 9 kHz to 20 GHz
- Low trace noise: <0.004 dB rms at 70 kHz IFBW
- Wide dynamic range: >123 dB
Keysight 8722ES Vector Network Analyzer, 50 MHz - 40 GHz
- 50 MHz to 40 GHz
- Up to 110 dB of dynamic range
- Excellent measurement accuracy
Wavecrest SIA 3000 Signal Integrity Analyzer
- Infiniband - Test to compliance on all channels simultaneously at speeds up to 4.5Gb/s per channel
- Rambus DRCG - Perform full DRCG validation in seconds
- Fibre Channel and Gigabit Ethernet - Test to compliance on all patterns and all channels simultaneously
Tektronix TTR500 Series Vector Network Analyzer (VNA)
- Full 2-port 2-path S-parameter measurement (S11, S21, S12, S22) in a variety of formats.
- Complete vector network analysis capability with Tektronix VectorVu-PC™ software.
- Built-in bias tee accessible on both ports to bias active devices.
Tektronix RSA306 USB Real Time Spectrum Analyzer
- 9 kHz to 6.2 GHz frequency range
- ACER Laptop with pre-installed SignalVU-PC software included
- +20 dBm to -160 dBm measurement range
Anritsu MS2726C Handheld Spectrum Analyzer
- Measure occupied bandwidth, channel power, ACPR, and C/I
- Dynamic Range of >104 dB in 1 Hz RBW
- Phase Noise of –100 dBc/Hz @ 10 kHz offset at 1 GHz
Rohde & Schwarz FSH313 Handheld Spectrum Analyzer w/ Tracking Generator
Tektronix RSA518A Real-Time Spectrum Analyzer
- 9 kHz to18.0 GHz frequency range covers a broad range of analysis needs
- 40 MHz acquisition bandwidth enables real time analysis for transient capture and vector analysis
- High speed full-span sweeps (70 GHz/sec) for fast setup and discovery
Anritsu MS2026A Vector Network Analyzer
- Frequency Range: 2 to 6000 MHz
- Frequency Accuracy: 25 ppm
- Frequency Resolution: 10 kHz
Rohde & Schwarz ZVH8 Cable and Antenna Analyzer
- Frequency range from 100 kHz to 3.6 GHz or 8 GHz
- 100 dB (typ.) dynamic range for filter and antenna isolation measurements
- Built-in DC voltage supply (bias) for active components such as amplifiers
Keysight FieldFox N9923A Network Analyzer (Agilent N9923A)
- Built-in QuickCal technology enables calibration without a cal kit
- Best measurement stability over time and temperature
- Industry´s only handheld network analyzer with MIL PRF 28800F Class 2 compliance with no exceptions
Rohde & Schwarz PR100 Portable Receiver
- Ergonomic and rugged design for portable use
- Detection of unknown signals
- Frequency scan and memory scan